中文English
Today to share the knowledge that the car wireless air pump is not charged for a few seconds, which will also explain why the car wireless air pump is not charged for a few second...

The car wireless air pump is not charged for a few seconds (the car wireless air pump is not charged for a few seconds)

Today to share the knowledge that the car wireless air pump is not charged for a few seconds, which will also explain why the car wireless air pump is not charged for a few seconds, if you happen to solve the problem you are facing now, don't forget to pay attention to the site, start now!

< ul>
  • 1, What is the reason why the inflator pump in the car often stops automatically?
  • 2, What's wrong with the car's air pump not filling?
  • 3, The reason why the car pump does not flush
  • What is the reason why the inflator pump in the car often stops automatically?

    The reasons for the car's air pump to ring and not move may be as follows: air pump engine failure: If the engine of the air pump does not start normally, it may be due to washingIn the process, the distributor, ignition module, spark plug, and high voltage line are flooded or the inertial switch is disconnected. At this time, it is necessary to check whether these parts are normal and repair or replace them in time.

    Check whether the car engine is started. If it is not started, it may be caused by insufficient power supply of the car power supply. Check whether the power cable is damaged, resulting in power failure. Consult the car factory to see if the car power supply has overload protection, some cars the cigarette lighter plug current output is relatively low, when the current is slightly larger, it will cause the air pump to stop working, plug it up and can be inflated.

    Car pump pumpWhen, it will stop by itself, it is because the piston heat dissipation is not good, which is overheating protection.

    What's wrong with the car's air pump not filling?

    1, the reason why the car air pump can not be inflated: internal structural problems: the shrapnel built into the air pump may harden after a long time of use, and can not recover the elasticity normally. When the reservoir reaches the preset pressure, the rebound of the shrapnel is hindered because of the counter-pressure action of the reservoir. This may cause the pump to fail. Pipeline blockage: The pipeline of the air pump may be blocked, affecting the flow of gas.

    2, that is, the pump pipe is blocked, if the pipe is blocked, it is very good to check, that is, to disassemble the pump pipe from the side of the dryer, and start the pump if the pipeline comes out with black smoke, that is, the pump pipeline is blocked, the solution is to replace the pump pipeline.

    3, first of all, you need to check whether the power supply of the car air pump is normal. Make sure that the power plug is not loose or damaged and that the power adapter or battery is working properly. If there is a problem with the power supply, it should be replaced or repaired in time to ensure that the pump can receive the power supply normally. Secondly, check whether the circuit of the air pump is smooth. playTurn on the air pump and carefully observe whether the circuit is broken or in poor contact.

    4, the car air pump has been ringing but not out of the problem may have the following reasons: check the power line and smoke hole is clean, the fuse is well energized, if the power line and smoke hole is not clean or the fuse is not energized, the air pump will not work normally, resulting in no reaction of the machine. At this time, it is necessary to clean the power cord and smoke hole of the air pump. If the fuse is damaged, it is necessary to replace the fuse.

    5, the reason for the failure of the car air pump is not inflated when the car air pump cannot be normally inflated, it is possibleThe problem may have the following reasons: Check whether the power cord and the smoke hole are clean, and whether the fuse is well-powered, if the power cord and the smoke hole are not clean or the fuse is not powered, the pump will not work normally, resulting in no reaction of the machine. At this time, it is necessary to clean the power cord and smoke hole of the air pump. If the fuse is damaged, it is necessary to replace the fuse.

    3, first of all, you need to check whether the power supply of the car air pump is normal. Make sure that the power plug is not loose or damaged and that the power adapter or battery is working properly. If there is a problem with the power supply, it should be replaced or repaired in time to ensure that the pump can be positiveOften receives power supply. Secondly, check whether the circuit of the air pump is smooth. Turn on the pump and carefully observe whether the circuit is broken or in poor contact.

    4, the air pump is generally not hit the gas: the valve disc or spring is broken, the piston ring is broken. The cylinder will pull when there is no oil. Air pump because of slow pumping, insufficient air pressure and into the factory maintenance, after inspection and judgment that the pump itself is the problem.

    5, the reasons for the air pump not on the gas may include: the internal shrapnel of the air pump softers for a long time, and can not spring up, resulting in the pressure of the air reservoir can not continue to work after reaching a certain degree. At this point, replace the pump directlyThe pump line is the solution. The tube of the air pump is blocked, which prevents the gas from entering the air cylinder and affects the inflation. To solve such problems, clean or replace the pipes.

    The introduction of the car wireless air pump is not charged for a few seconds, thank you for taking the time to read the content of this site, more about the car wireless air pump is not charged for a few seconds what reason, the car wireless air pump is not charged for a few seconds do not forget to find the information in this site.