This article gives you a talk about the Mi 9 wireless car charging disconnect, and millet wireless car charging will interrupt the corresponding knowledge points, I hope to help you, don't forget to collect this site. < / p > < h2 > the article directory list: < / h2 > < ul > < li style = 'margin - bottom: 3 px; list-style: none'>1, Mi nine original data cable connection car USB how to disconnect every few seconds in the disconnect?
1, power management Settings: Some phones may pass the power management SettingsTo limit the power consumption of external devices, resulting in disconnected connections. Please check if there are relevant power management options in your phone's Settings and try adjusting them to allow continuous power to the USB stick. USB port status: Ensure that the USB flash drive is properly connected to the USB port of the phone and is not loose or dirty. Unstable contact may cause the connection to break.
2, first unlock the Mi 9, in the system: MIUI 9 click the "Settings" icon to open the Settings page. Swipe to the bottom of the page and click on "About Mobile Phone" to open the details page of mobile phone information. Click [Version number] repeatedlyUntil you enter Developer Options. Then in the Debugging area of the Developer Options page, enable USB Debugging.
3. Insufficient memory When the memory of the phone is insufficient, the carplay function may be stuck or disconnected when loading a large amount of data. You need to clean your phone's memory to ensure that your phone has enough running memory to run carplay. At the same time, it is also necessary to ensure that the relevant permissions of the mobile phone to connect to the carplay function are enabled. If there is a problem with the vehicle system itself, it may be necessary to refresh the vehicle system to solve itXiaomi after-sales! -- Seek professional maintenance. Similarly, if the balance car shows a green light that cannot be charged, it may be a charger failure or a broken charging loop.
2, millet balance car charger does not go into the electricity, the solution is: check whether the balance car charger has a problem, restore factory Settings, view the line, low-voltage slow charge, repair and activate the battery, contact after-sales personnel, etc.
3, therefore, when we can not charge the balance car at home and charge for a long time, the battery is likely to be damaged. At present, we can only contact the after-sales service department to repair or replace the battery.
4,First of all, consider the charger is bad, if you change the charger or this is a short circuit. Probably drained the battery until it was completely dead. This situation is likely to cause the battery to be charged for a long time. Leave the charger plugged in. Check back in a few hours. If it still does not return to normal, it is estimated that the battery is broken. If you don't know what the problem is, go to the after-sales consultation as soon as possible to solve the problem.
1, try to restart or the above method, if not,Do not rule out the mobile phone wireless charging module problem, it is recommended to go to after-sales testing. Mi 9 wireless charging did not respond, you can first see if the power is turned on. Because the power's not on, it can't be charged.
2, first of all, we need to confirm whether our millet 11 supports wireless charging function. You can view this information in your phone's Settings. Enter "Settings" - "Battery and Performance" - "Wireless charging", if the "wireless charging" option appears, it indicates that the device supports wireless charging. After confirming that the device supports wireless charging, we need to prepare a wireless charger that supports the Qi standard.
3, Mi 9 wireless charging did not respond, you can first see if the power is turned on. Because the power's not on, it can't be charged. Secondly, you can change another Xiaomi data cable to see if it can be charged, if it can be charged, it means that there is a problem with the front charging line. If not, can not charge, you can take the ID card, take the mobile phone to the local millet after-sales service there to test, to see whether the phone itself has a problem can not charge.
4, Mi 10 changed the tail plug without wireless charging can be replaced with other wireless charging base for charging. Locate the fault of the mobile phone or wireless chargerThe failure of electrical appliances, non-millet wireless charger may not be compatible with the mobile phone, resulting in abnormal wireless charging function, must use millet official wireless charger for wireless charging.
Should send the jack. Or there's something wrong with the phone's tail plug. I had a similar problem before. Got it fixed. Looks like there's a problem with the Mi 2 Series tail plugs.
Original data of Xiaomi mobile phoneLine connection car USB how to disconnect every few seconds and then disconnect again? This situation is generally related to the compatibility of the car. You can try to change the data cable to see if it can return to normal.
The reason why the car usb repeatedly disconnects and then connects may be because the usb contact is poor or the USB power supply is unstable. Car charger is a car charger powered by a car battery, which is often used in the field of lithium battery charging for portable and handheld devices. The car charger is versatile and equipped with four AC converters of US regulation, UK regulation, Austrian regulation and European regulation, which can meet the charging needs under different conditionsPlease.
Check whether the Bluetooth device is far away from the machine. Whether the phone is in airplane mode or Super Power saving mode. If enabled, the phone will turn off the Bluetooth function. To use Bluetooth, turn it on again. Turn the phone off and restart. If the Bluetooth connection is still automatically disconnected, it is recommended to replace another Bluetooth device.
The connection between the charger and the data cable will also lead to poor contact, check whether the connection between the charger and the data cable, the data cable and the mobile phone is loose, resulting in poor contact, if so, it can be fixed.
Millet phone repeatedly disconnected when charging may be the charger and numberAccording to the cable is partially damaged, check the charger and data cable, if there is damage, need to be replaced in time to avoid greater losses. Check the phone connector for foreign objects and clean it with tools such as cotton swabs and alcohol. It may be that the mobile phone battery is damaged, and it needs to be repaired and replaced at the official repair point of the mobile phone brand.
The introduction of Mi 9 wireless car charging disconnection and millet wireless car charging will be interrupted is over. Do you know if you can find the information you need? If you want to know more about this, remember to follow this site. < / p >