This article gives you a talk about Huawei 66w wireless charging fault welcome, and Huawei wireless charger can not be charged how to do the corresponding knowledge, I hope to help you, don't forget to collect this site. < / p > < h2 > the article directory list: < / h2 > < ul > < li style = 'margin - bottom: 3 px; list-style: none'>1, How to check whether the lamp of Huawei 66W charger is normal?
1, the time used is too long, reached the charge and discharge cycle, should be replaced with a new battery. Purchased a low-quality cell made of batteries, it is easy to internal short circuit display a full charge, but there is no electricity;Or damage can not be identified and charged.
2. Huawei 66W charger will enter the protection mode after it has been idle for a long time and has not been charged. After connecting the charger, the reaction will be as follows: the indicator light will be white for four times and then off.
3, normal charging state, full charge state, battery fault state. Normal charging state: In the normal charging state, there will be two indicators, the first is the power indicator, the second is the charging indicator. Both indicators light up when the charger is connected to a power source and starts charging. Fully charged:When the battery is fully charged, only the charge indicator lights up, while the power indicator goes off or stays off.
4. If the Huawei charging treasure turns green when charging, it means that it is charging the first half of the flashing electricity. The charging method problem, you see whether the direct charge contact sheet and the battery correctly contact, change the position (there are several contacts on the battery, try it in pairs), or press (some move) the transfer switch on the charger, it may be done.
5, the status indicator can reflect the battery power status: red steady on: the battery power is 2% to 10%; orangeChang Liang: The battery power is 10% to 90%; Steady green: The battery is high (greater than 90%) and charging is nearly complete or has been completed.
6, when the mobile power is charging, the indicator light flashes, that is, it is not charged, this is because the mobile power into the charging protection state, this time is not charged, the mobile power is plugged into the USB output of the computer for 2 hours to release the charging protection state, and then it can be used normally.
1. Try to replace another wireless charging base to charge the device, and determine whether the fault is the fault of the mobile phone or the wireless charger. The non-Huawei wireless charger may be incompatible with the mobile phone, resulting in abnormal wireless charging function. If the preceding problems persist, you are advised to back up the phone data (third-party applications such as QQ and wechat need to be backed up separately), bring related accessories and purchase vouchers, and go to a nearby Huawei customer service center for testing.
2, check the charger and power adapter: make sure that the wireless charger you use is compatible with the power supplyThe device is compatible with Mate 30. Sometimes, incompatible chargers may not work properly. It is recommended that you use original or certified chargers and adapters. Clean and inspect the device: Check your Mate 30 and wireless charger for any dust, dirt, or foreign objects. These substances may interfere with the normal operation of the wireless charging function.
3, the methods that can be taken in this case are: determine that the phone is compatible with the wireless charger, check the charger and the power adapter, check the alignment between the wireless charger and the phone. Make sure the phone is compatible with the wireless charger: Make sure your phone supports itWireless charging features, and wireless chargers are compatible with your phone model. Different phone models may have different charging standards, so you must use a wireless charger that supports your phone model.
4, the reason why mate30 can not wireless charging: the wireless charging base indicator is not bright, please check whether the connection between the charging base, data cable, charger and power supply is in bad contact, it is recommended that you re-plug once. Is there anything else between the phone and the wireless charging base? If so, please remove it. Wireless charging converts electrical energy into magnetic energy for transmission to the phone, and if the magnetic energy is interfered with, charging will be affected. Mobile phone locationLight up. The green light doesn't come on. And then I can't charge my phone... '> Huawei 66W Super Fast charge mobile power supply charging light. The green light doesn't come on. And then I can't charge my phone...
1, it may be that the fast charge protocol interaction is abnormal, it is recommended to reinsert the data cable. Ensure that Huawei standard data cable is used. To ensure charging safety, you can enter the fast charge/Super fast charge mode only after using Huawei standard data cable.
2, it is recommended to try several times, if the phone plug-in charging line has no reaction (such as charging icon, indicator light), it may be chargingIf the interface is faulty, it is recommended to take the purchase invoice to the after-sales service point for repair.
3, there may be several reasons for not being charged with a charging bank. If the charger can be charged, then there are several situations, one is that the charging treasure is broken or the charging treasure is not opened, or the charging treasure is exhausted. ② If the use of other chargers can not be charged, the phone interface may be broken, to find a professional repair. The interface is faulty.
4. Huawei 66W charger will enter the protection mode after it has been idle for a long time without charging, and the reaction after connecting the charger is: the indicator light is 4 whiteTurn off, then press the power button, an indicator green light flashes three times, and then turn off, unable to charge.
5. Description of the indicator status of Huawei 66 W Fast charging mobile power supply: The first indicator of the mobile power supply is green when it is fast charging, and the first indicator of the mobile power supply is white when it is ordinary charging. All other indicators are white when they are on.
6, the mobile power charging light is on, the mobile phone charging light is not on. There are several reasons: the mobile power supply default setting of the program to charge the phone is not displayed. Due to the different Settings of this mobile power supply, as long as you check the charging symbol after the phone is connected, you can. Need to check separatelyTo see the power, you can press the power button to see. Mismatched data cable caused.
1, the time used is too long, reached the charge and discharge cycle, should be replaced with a new battery. Purchased a low-quality cell made of batteries, it is easy to internal short circuit display a full charge, but there is no electricity; Or damage can not be identified and charged.
2, Consultation record · Answer in 2021-11-02 Huawei 66w charger can not be charged Hello, in this case, it is recommended to use Huawei fast chargeElectrical and data cables charge the mobile power supply. In addition, poor interface contact will also cause failure to charge or slow charging, it is recommended to reinsert the charging cable and try.
3. Huawei 66W charger will enter the protection mode after it has been idle for a long time and has not been charged. After connecting the charger, the reaction will be as follows: the indicator light will be white for four times and then off.
Huawei 66w wireless charging fault Welcome to talk about it here, thank you for taking the time to read the content of this site, more about Huawei wireless charger can not be charged how to do, Huawei 66w wireless chargingFault welcome information don't forget to find on the site oh.